Cloth stuck in tuning slide!

[CKH]

I was cleaning out my horn today and got some t-shirt material stuck in my third valve slide. Any ideas on how to get it out?

Christian

[uieuph]

air compressor

[carbogast]

Obviously, a repairman could get it out in a jiffy without damaging the slide in any way. If you can't do this, then your two basic tactics are applying pressure (pushing) or pulling. In either case friction is a problem, so a little oil will help.

There are some repairman that contribute to this forum that you may wish to wait to hear from before attempting anything. I am not a repairman, but have some ideas as follows:

An air compressor (already suggested) would be good and if you have good water pressure at the tap, that might also do it. Either way, you will need to cobble together a fitting.

Consider pulling. You might be able to fish it out with a small hook and line. If you happen to have a steel guitar string, you might be able to work it past the jam. Then attach something to one end that will allow you to pull on it and drag the cloth out. Don't forget the oil.

Finally, reconsider a repairman.

Good luck and don't panic, it will come out.

- Carroll

[carbogast]

One thing, you weren't specific about the exact nature of the material caught in the slide. Is it a jam, or is it just a shred of material caught in the spit valve area?

- Carroll

[CKH]

It's in the actual tuning slide. I was cleaning them out individually with a snake. I took a t shirt and cut it up into strips and attached it to the snake with via a rubber band. I couldn't push it all the way through, so I pulled it out and the shirt part and rubber band is still in there.

[davewerden]

Without seeing it, I don't know all the angles, etc. But from the sound of it I would suggest dripping some liquid soap down the tube so it soaks the cloth and rubber band. Then the first thing I would try is just to blow hard on the end of the tube furthest away from the clog and see if it will come out (the soap helps provide a better seal to build up air pressure and also lubricates it). If that doesn't work, or if there is no decent air seal around the clog, then I might try pushing a standard cleaning snake down to see if you can push it out.

[CKH]

Thanks for all the replies. I can't push it out with a snake because the angle is too sharp and it won't go through the entire way. Would a pressure washer with no water work? (I guess I'm asking it it would only shoot out air)

[RickF]

I think Dave Werden's suggestion is a good one. The soap would help lubricate and seal so you could blow it out... unless it's really jammed in there.

You could also try using a 'grabber tool' or 'pick up tool' like this one:



This one is 22" long so should be able to reach down the long 3rd slide. Even has a light on the grabber end. Not sure how remote you are, but this type tool should be available at any home store like Lowe's or Home Depot or ACE hardware. The one pictured is sold at Grainger

[daruby]

Originally posted by: RickF

I think Dave Werden's suggestion is a good one. The soap would help lubricate and seal so you could blow it out... unless it's really jammed in there.



You could also try using a 'grabber tool' or 'pick up tool' like this one:







This one is 22" long so should be able to reach down the long 3rd slide. Even has a light on the grabber end. Not sure how remote you are, but this type tool should be available at any home store like Lowe's or Home Depot or ACE hardware. The one pictured is sold at Grainger

Appropriately called a "pickle plucker"! ;-)

[CKH]

I tried to fish it out with a bent metal hanger but it didn't work. I'll just head to the repair shop tomorrow and see what they can do.

Thanks for all the help!